Aantar

Aantar POS

Pairing codes

A pairing code lets one till join the store server once; make it on the set-up page, with its QR code and pairing link.

Where: Store server set-up page ▸ 3. Tills ▸ Make a pairing code

A till joins the store server once, with a pairing code. The code proves that someone who may change the store server let this till in. After that the till is remembered: later starts open on the PIN pad with no code.

What a pairing code is

  • A short code, like ABCD-EFGH, made on the store server's set-up page.
  • It works once, for 10 minutes, for one till.
  • It comes with a pairing link: one line holding the server's address, its certificate fingerprint and the code. The same line is shown as a QR code.
  • The till checks the server's certificate fingerprint before it sends the code. A link that names another fingerprint pairs nothing and leaves the code unused.

Make a pairing code

  1. Open the store server's set-up page and sign in. See The set-up page.
  2. Go to 3. Tills.
  3. If the page asks which network address the tills must use, pick the one on the shop's network.
  4. Press Make a pairing code.
  5. The page shows the code, the QR code, the time it expires and the Pairing link with a Copy button.
  6. Give the code (or the link) only to the person at that till, and pair the till within 10 minutes. See Connect a till to the store server.

Important: The pairing link holds the code. Anyone who has it in the next 10 minutes can pair a computer. Do not post it in a group chat or by e-mail to a shared mailbox.

Make a code at the till itself

A manager who knows the store server's admin password can make the code on the till:

  1. On the till's Connect to the store server screen, type the Store server address.
  2. Open I look after the store server.
  3. Type the Store server admin password and press Make a pairing code for this till.
  4. Check the certificate fingerprint when asked. The code fills in by itself.

Check which computers are paired

Under 3. Tills, Paired computers lists every computer paired with the server: its name, when it was Paired and when it was Last seen.

To take a computer off (a stolen laptop, a till PC you threw away), press Revoke on its line and confirm. It will have to be paired again to sign in. A till that the server removed says The store server no longer knows this till at its next start, with Pair this till again.

Tip: 3. Tills also shows Till stations: with the number set up and the number your licence allows. A code is no use on a till the licence has no room for.

If something goes wrong

  • The code was refused: it was used already, or more than 10 minutes passed. Make a new one.
  • "Too many wrong attempts. Wait ten minutes." Too many wrong codes were typed from that computer. Wait, then try once with a fresh code.

Related articles

Something unclear or out of date? Write to support@aantar.com and name this page.