Aantar

Aantar POS

Two rules for every key: number first, amounts in cents

Key the number first and then press the key it is for, and key every amount in cents.

Two rules cover almost every key on the selling screen. Learn them first: the rest of the manual assumes them.

Rule 1: number first, then the key

Key the number on the pad, then press the key that says what the number is. The number shows on the entry line until you press the key.

You want to Key Then press
Ring item code 4011 4011 PLU Enter
Sell 6 of the next item 6 Qty, then scan the item
Ring $4.99 in a department 499 the department key
Take $20.00 in cash 2000 Cash
Take 10% off the line you touched 10 % off line

Rule 2: amounts are keyed in cents

The till puts the decimal point in for you. Key every amount as cents, with no point.

Key The till reads
150 $1.50
2000 $20.00
5 $0.05
1000 $10.00

A quantity, a percent and an item code are whole numbers and are keyed as they are: 6 is six, 10 before % off line is ten percent.

You may also key the point with the . key when it is quicker: 1.5 is $1.50 and .75 is $0.75. Without a point, the last two digits are always the cents.

Note: This applies to the standard selling screen (the lane screen). On the older classic selling screen, chosen under Till settings ▸ Selling screen, the payment panel reads 40 as $40.00 and the point keys the cents.

Correcting what you keyed

  1. Press Back to take off the last digit.
  2. Press Clear to empty the entry line and start again.

Tip: Look at the entry line before you press the key. What it shows is what the key will use.

Important: 20 before Cash is twenty cents, not twenty dollars. When a customer hands over a note, press the yellow quick cash key for that note instead of keying it. See Take cash.

What happens next

Ring your first items: Scan a barcode, Key a code or PLU and Sell several of the same item.

Related articles

Something unclear or out of date? Write to support@aantar.com and name this page.