Aantar POS
The scanner does not read
What to check when a scan rings nothing, rings the wrong thing, or leaves the code on the entry line.
Where: The selling screen
The till reads a USB scanner as if it were a fast keyboard: the scanner types the code into the entry line and ends it with Enter. The till tells a scan from typing by its speed. Most scanner problems come from where the code lands, or from a scanner that does not send Enter.
Before you start
- Key the same code on the pad and press PLU. If the item rings, the catalogue is fine and the problem is the scanner. If it says Not found:, see "Item not found".
The scanner beeps, but nothing rings
Likely cause: the code went somewhere other than the entry line, or a band is waiting for an answer.
- Look at the box on the left of the entry line. A scan rings an item only when it shows CODE.
- If it shows PIN, ID or WEIGHT, answer or cancel the band above the items first. See Questions show as bands, not pop-ups.
- If a panel with its own typing box is open (for example Find an item), the scan goes into that box. Close the panel with Esc; the next scan lands on the entry line again.
- If another program has the focus (a browser, a Windows message), click once on the till's entry line, then scan again.
The code stays on the entry line
Symptom: the digits of the barcode appear on the entry line, but no line is added.
Likely cause: the scanner does not send Enter after each code.
- Press PLU (or Enter) to ring the code that is there.
- Set the scanner to add Enter (a carriage return) after each code. Most scanners do this by scanning a set-up barcode from their own manual.
- Scan an item: one beep and one line means it is right.
The scanner does not beep or light up
Likely cause: the scanner has no power, its cable is loose, or it cannot read that kind of barcode.
- Unplug the scanner's USB cable and plug it in again, in a different USB port if possible.
- Open Notepad on the PC and scan an item. If no digits appear in Notepad, the scanner or its cable is at fault, not the till.
- If only some barcodes fail (a crumpled label, a barcode printed on a curved can), key the code under the barcode and press PLU. See Key a code or PLU.
- If one kind of barcode never reads, turn on that kind in the scanner's own set-up (its manual lists the set-up barcodes).
A scan rings a quantity or the wrong item
Likely cause: digits were keyed on the pad before the scan. A number keyed first, then Qty, sets how many of the next item ring.
- Press Clear before scanning, so the entry line is empty.
- To correct a line already rung, touch it, key the right quantity and press Qty, or press Void line. See Take a line off.
Tip: After a start, the till may say The items are still loading; scan again in a moment. The scanner is fine: wait a few seconds and scan again.
If something goes wrong
If Notepad shows the digits but the till still does not take the scan, note the scanner's make and model and see Getting help from Aantar. For scanners known to work, see Barcode scanner.
Related articles
Something unclear or out of date? Write to support@aantar.com and name this page.